A troublesome thread popped up at RevitForum.org the other day and DMapes came to the rescue. I haven't encountered this peculiarity before, and now that I know about it it's a bit surprising that I haven't. I guess I've just been lucky.
When you use the Underlay setting in Revit MEP you run the risk of altering the way your pipe fittings (duct fittings too in views using Detail Level: Coarse) scale and/or look. Here's a good and bad side by side.
The pipes on the left are good but those in the view on the right are smaller and halftone, as a result of using the Underlay setting.
Set to None the fittings look correct, but using the same level the fittings are associated with as the underlay equals sadness. It doesn't seem to mind if you use other levels as the underlay though. Careful with your underlay!
When you use the Underlay setting in Revit MEP you run the risk of altering the way your pipe fittings (duct fittings too in views using Detail Level: Coarse) scale and/or look. Here's a good and bad side by side.
The pipes on the left are good but those in the view on the right are smaller and halftone, as a result of using the Underlay setting.
No comments:
Post a Comment